 |
 |
 |
 |
Clamp On Boat Cup Holders for Trolling Motors
$39.95
Our clamp-on boat drink holders for trolling motors, excluding the UV protected cup insert, are made of durable high quality UV protected marine grade starboard to ensure they last for years after installation.
Once installed, our holders will rotate 360 degrees around the trolling motor shaft to any position desired but will not move up or down without considerable force and will cause no damage to the surface they are mounted on. They can withstand a lot of punishment and still will not move up or down.
With no moving parts, they are extremely tough and durable. Each holder is a precise custom fit for each trolling motor shaft size variation.
The large cup fits a can with a foam koozie or 24 ounce tumbler. The small cup fits a bottle with a koozie, a can without a koozie, or remove cup insert for a togo coffee mug. Included with your custom holder is the removable cup insert, 2 stainless allen head mounting screws, and the allen wrench for installation.
You can use calipers or a tape measure to get the outside diameter (OD), use a flexible tailors ruler to measure the shaft of the trolling motor and get a circumference,
or you can print out our custom ruler and wrap it around the motor shaft you will be mounting your drink holder on.
Available in white or black.
Click here for printable ruler.
Large cup dimensions:
Outside width 4 inches, inside width 3 1/2 inches.
Total cup depth is 3 1/4 inches, including the 15/16 inch recessed bottom.
Small cup dimensions:
Outside width 3 1/4 inches, inside width 2 5/8 inches.
Total cup depth is 3 inches.
Pipe size chart.
Shipping Notice: Because all
of our marine drink holders are custom made, normally your order will
ship within 48 hours.
However on rare occasion some products may take 3-4 days before orders
are shipped. Thank you for understanding.
Please double check your measurements for your clamp-on drink holders. We want
to be sure you order the correct size for a nice snug fit. We don't
want y'all to have to pay all that extra shipping to get it to us and
back to you again, or if you don't know the size you can order our
new universal clamp-on mount drink holders, a single holder will fit a wide range of pipe sizes.
Please print the ruler or call us if you need
assistance, (855) 777-CUDA.
Thank you. Tight Lines!!!
All Holders are Invented, Custom Made, and Manufactured, by us Cuda's Customs, Right Here in the USA.
