 |
 |
 |
 |
Patented Universal Clamp-on Marine Knife Pliers Tool Holder
Durable high quality completely weatherproof marine
accessories made of long lasting UV protected marine grade polyethylene
and calcium carbonate to ensure they
last for years in harsh outdoor elements.
The "Manta Ray" tool holder will hold 1 knife within sheath, 1
hook sharpener, 2 pairs of pliers, and 12 hooks or tackle (6 on each
side).
ONLY $19.95
- Our patented completely weatherproof universal clamp-on marine tool holders adjust to fit popular pipe sizes.
The smaller universal clamp fits from 1 1/4 inch outside diameter to as small as 3/4 inch OD.
(For all smaller supporting pipework & hand and grab rails)
The larger universal clamp adjusts to fit pipe sizes from 2 inch outside diameter to 1 1/2 inch OD.
(Fits most T-tops, Towers, Center Consoles main support pipes)
- Made using a marine polymer that is stabilized to resist saltwater, chemicals, and UV damage. It will not breakdown, mold, rot, or delaminate and cleans quick and easy.
- Once installed, our holders will rotate 360 degrees around your pipe to any position desired but will not migrate down the pipe without force and will cause no damage to the pipe's surface or powder coating they are mounted on.
-
They can withstand a lot abuse and with no moving parts, they are extremely tough and durable.
- The knife slot is 1 1/4 inch wide and 1/8
inch thick, there is a 1/4 inch hole in the middle for a dehooker or
venting tool. Hole can easily be drilled out to accommodate bigger tools
if necessary.
Click here for printable ruler.
You need 1 inch clearance for the back V half of holder for those tight spaces in between the grab rails, windshields and consoles.
Pipe size chart.
Included are two 316 marine grade stainless steel phillips mounting screws.
Shipping Notice: Because all
of our marine drink holders are custom made, normally your order will
ship within 48 hours.
However on rare occasion some products may take 3-4 days before orders
are shipped. Thank you for understanding.
Please double check your measurements for your clamp-on drink holders. We want
to be sure you order the correct size for a nice snug fit. We don't
want y'all to have to pay all that extra shipping to get it to us and
back to you again.
Please print the ruler or call us if you need
assistance, 866-730-1524.
Thank you. Tight Lines!!!
All Holders are Invented, Custom Made, and Manufactured, by us Cuda's Customs, Right Here in the USA.
